Best ram for imac 27 late 2013
I think it is better to replace the processor first (for no special reason). If you are done removing the board it is time to replace the parts. It is not easy as it sounds but you will figure it out. Now disconnect every connector that is attached to the board and remove all the screws. Disconnect the fan from the board, then use a suitable screwdriver and remove all the screws from the fan and pull it out. You don’t have to remove the speakers and the disc drive. It is a bit difficult process to explain but I’m going to make sure you don’t miss anything at all.Īs you can see there are the hard disc, speakers and the board. The most difficult thing in this process is removing the motherboard (or logic board). Replacing the partsĪs I said before we are going to replace the outdated processor, RAM and the storage device with something new. Now again, use the sharp object to remove any adhesive left in the bottom part of the display and carefully put the display aside. Now you will be able to see two cables connecting the display to the motherboard, disconnect them from the motherboard. When you are done prying it, use a hand to pull it for a little (don’t rip it off, be patience). Now gently use the pry tool to lift up the display (start from the top and leave the bottom for a moment). Start from a corner and return to that corner again (it means do it twice to make sure the adhesive is cut off properly). If you don’t have the suitable tools you can buy a specific tool kit which is specially made for this job from Amazon (it also includes adhesive tapes for reattaching the display).įirst of all, slowly put the sharp object (or the tool) between the display and the back panel and drag around the display carefully and slowly. So, what you need is a prying tool and a something sharp and thin (like a very small knife or using a sharp plastic object). It is a very careful thing to remove it without scratching the screen. The display of an Apple iMac is very thin and glued to the back panel. It looks like four simple steps but trust me it isn’t. These are the steps that you need to follow, Now we are going to replace those three parts with latest and much more efficient parts. Originally, the 2013 iMac has a 3.2GHz Intel Core i5 processor, an 8GB of 1600MHz DDR3 memory that can be upgraded to a max memory of 32GB and a 1TB hard disc drive. The second is replacing your outdated iMac parts without a sweat. Obviously it is worth buying if you are looking for a 4K retina display and a configurable to 32GB memory. The first one is buying a new iMac which costs more than 1000$. If you have an iMac and you are expecting some performance boost you have two ways to choose. So in this article we are going to talk about the 27” iMac which was released in late 2013. Since everyone doesn’t have a MacBook, we thought it would be good to do write something about the iMac computer. Pushing the 2013 iMac to its limits using 350$ budget!